Flexo Folder Gluer Specifications PRODUCTION CAPABILITY Description Dimension Minimum (in) Maximum (in) Untrimmed Sheet A 22.50 114.50 / 108.75* Trimmed Sheet B 22.00 114.50 / 108.75* Glue Flap Panel C 5.50 40.00 End Panel D 10.25 / 5.50 40.00 Glue Flap Panel & End Panel E 11.00 56.00 Sheet Width F 15.00 46.00 Sheet Width (skip feed) F 60.00 Glue Lap Width G 1.00 1.75 Maximum Speed 15,000 per hour Maximum Caliper 0.560 inch Minimum Caliper 0.060 inch Maximum Print Length 109.0 inches Maximum Die Length 108.5 inches * depends on crushing and trim heads set-up QUICK SET-UP Fixed Print Stations Fixed stations are always operator accessible. An order can be set-up on idle stations while a current order is running overhead, maximizing run time. Windows-Based Control System Gives flexibility to set up the order, run the order, add to order. Servo Motors Servo motors drive each print cylinder independently, allowing rapid, precise changes in print registration. Vacuum Transfer Vacuum transfer begins at the feed pull rolls and continues to the slot/crease section. Walk-in design makes print monitoring easy. Die Cut Section Die cutting allows greater flexibility with orders to be run. Cutting dies may be mounted in advance while a non-die cut order is being run. SQUARE BOXES, TRUE FOLDS Dual Slotting & Scoring Dual slotting and scoring along with pre-creasing are standard. Result: square boxes, less waste, higher productivity. Extra Long Rails Longer rails in the folding section make more consistent, true folds.
	© 2005–2010 Hycorr Machine Corporation